Carbon Galvanized Steel Sheet Slitting Machine Simple Hydraulic RS
This edge trim is taken up on a scrap winder. If the material to be
slit is extremely thin, a looping pit can be used to take up the
varying thickness of the mults as the edge cuts are generally
thinner than the center cuts. The thin the material, the longer the
lineal footage in the master coil.
The looping pit will take up the additional volume prior to
entering the tension stand. The tension stand is located prior to
the recoiler. A tensioning device is needed because the master coil
is crowned or larger in diameter in the center of its width than at
Without a tension stand, the slit material from the center of the
master coil would take up more quickly while the outboard strips
would hang loosely. The recoiler is an expanding mandrel type. The
recoiler takes up the slit mults. The recoiler mandrel is fitted
with an overarm device which is a shaft with separator discs which
prevent interleaving of the narrower coil widths.
The position of the discs are directly in-line with the slitting
knives. The finished slit mults are banded on the outside diameter
and are pushed off of the recoiler mandrel onto an awaiting coil
car or turnstyle.
Steel Sheet Slitting Machine Introduction
- Minimum Burr on strip.
- Automatic Coil Loading
- 2 complete slitting heads for quick offline tooling changeovers.
- Straight edged recoiling.
- Economic efficency due to high automation level.
- Ease of Operation and Maintenance
- Slitting Lines are available in different sizes and models as per
the demands and specifications laid by the clients.
- It is available in different capacities and standards according to
the demand of the clients.
- These Slitting Lines are widely appreciated amongst our clients for
their user friendly designs and high resistance to temperature
These knives partially penetrate the coil stock causing a crack or
fracture on both sides of the stock, separating the mults from one
another. Rubber stripper rings are also employed depending on the
material thickness to attain a good edge so no burr is present that
will hinder downstream operations. As the material is slit, the far
outside edges of the coil have edge trim.
Steel Sheet Slitting Machine Specification:
|Model No.||RS 3.0-12.0||RS 4.0-16.0||RS 6.0-20.0|
|Coil Material||CR Coils , HR Coils, S.S Steel Coils, GI Coils, AL Coils, Copper
Coils Picking Oil Coils|
|Number of Strip||5～20||≤5||≤5|
|Electrical Control System||PLC Automatic control||PLC Automatic control||PLC Automatic control|
|COIL/ROLL DETAILS||Material||HR, CR, SS, GI, PPGI,|
|Steel Coil/Roll width||600-2500(Max)|
|Coil/Roll I.D||Φ500-760 mm|
|Steel Coil/Roll Weight||35T(Max)|
|knife pivot diameter||Ф360 mm|
|Knife pivot material||40Cr|
|Max slit quantity||4 pcs (16mm) 8 pcs(8mm)(Customized)|
|Whole line Dimension||45m(L)X10m(W)|
|Line direction||From right to left(Face to machine)|